MAGNETIC CLUTCH DISASSEMBLY/ASSEMBLY [MZ-CD 1.6 (Y6)]


B3E074061010W06

1. Disassemble in the order indicated in the table.

1
Nut
2
Pressure plate
3
Shim
4
Snap ring
5
A/C compressor pulley
6
Snap ring
7
Screw
8
Oil plug
9
O-ring
10
Stator
11
A/C compressor body

2. Assemble in the reverse order of disassembly.

3. Adjust the magnetic clutch clearance. (See MAGNETIC CLUTCH ADJUSTMENT [MZ-CD 1.6 (Y6)].)

Nut Removal/Installation Note

1. When removing or installing the nut, hold the pressure plate in place as shown in the figure.

2. When installing a new A/C compressor body, replace the recommended nut.

A/C Compressor Pulley Removal Note

1. Remove the A/C compressor pulley using any commercially available puller and appropriate round rod.

Screw Installation Note

1. When installing a new stator, replace the screw.

O-ring Installation Note

1. When installing a new oil plug, replace the O-ring.

A/C Compressor Pulley Installation Note

1. Install the A/C compressor pulley using any commercially available pulley, and the SST (49 T028 301).

Caution
• If the SST (49 T028 301) installation position is misaligned while press fitting the A/C compressor pulley, it could cause interference with the A/C compressor shaft resulting in damage. Press fit the A/C compressor pulley carefully while verifying the position of the SST (49 T028 301) and shaft.